Bamboo Fence Installation Guide

Simple, Secure Installation Design

Our bamboo panels are designed to make installation straightforward and reliable.

Three solid timber fixing rails on the rear of each panel
Every bamboo half pole is screwed to all timber fixing rails
No need to drill or screw through the bamboo – fixing is done between the bamboo poles, through the timber only
Panels are fully secured with just two screws in each timber rail

This construction means the panel is already structurally sound before it is installed. The fixing screws are simply anchoring the panel to your structure, not holding the bamboo together.

Installing Our Bamboo Panels

Depending on what you are fixing the panels to, installation methods may vary slightly. As shown in the photos, the key requirement is having a solid structural surface or frame to attach the panels to.

As long as there is a suitable structure behind the panel, our bamboo panels can be used to cover, screen, or clad almost any surface.

We’ve included real installation photos to show how we install our panels and how we recommend they are installed for the best long-term result.

Click on the Panda above to view installation photos. Alternatively, Click here.

Installation Shown the Way We Do It
Real Photos, Real Fixing Methods

Bamboo Panel Fixing Point Heights

All fixing point measurements below are measured from the bottom of the panel to the center of each timber support.

1800mm High × 900mm Wide

Bottom fixing point: 220mm
Middle fixing point: 900mm
Top fixing point: 1580mm

2400mm High × 900mm Wide

Bottom fixing point: 270mm
Middle fixing point: 1200mm
Top fixing point: 2120mm

2100mm High × 900mm Wide

Bottom fixing point: 222mm
Middle fixing point: 1050mm
Top fixing point: 1870mm

1200mm High × 1000mm Wide

Bottom fixing point: 220mm
Top fixing point: 970mm

This panel size uses two fixing points due to its reduced height